Sea Ray 290 Sundancer Manuale del Proprietario Pagina 58
- Pagina / 150
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
3.10
SECTION 3 • USING YOUR BOAT
290 Sundancer
®
C. On the dock, turn
OFF the dockside
breaker.
D. Disconnect the
dockside end of
the power cord.
E. On your boat,
disconnect the
power cord
from your boat
receptacle.
F. Clean the power cord, spray the cord ends with
moisture repellent, and store the cord in a dry
location on board.
You must keep the shore power cord and the plug
ends clean and dry. This is especially necessary if
your boat is used in salt water. Always clean and
spray your cord ends with moisture repellent before
using and before storing the cord.
C. MAINTENANCE FOR SHORE POWER CABLE
AND SHORE POWER INLET
The metallic parts of your cable and inlet are made
to resist corrosion. In salt water environment, life
of the product can be increased by periodically
wiping the exposed parts with fresh water, drying
and spraying with a moisture repellent.
A soiled cable can be cleaned with grease-cutting
household detergent. A periodic application of vinyl
protector will help both ends and cable maintain their
original appearance.
In case of salt water spray or immersion: Rinse
plug end and/or connector end thoroughly in fresh
water, shake or blow out excess water and allow to
dry. Spray with a moisture repellent before reuse.
Disconnect the power cable from power source before
performing maintenance.
! WARNING
C
D
DOCK POWER BOX
(F
IG. 3.10.1)
SHORE POWER RECEPTACLE
(FIG. 3.10.2)
E
- 290 Sundancer 1
- HIS MANUAL 5
- OUR RESPONSIBILITIES 5
- OURCES OF INFORMATION 5
- INTRODUCTION 6
- ERVICE, PARTS AND REPAIR FOR 7
- OUR BOAT 7
- ABOUT YOUR LIMITED WARRANTY 8
- NTRODUCTION 9
- ECTION 3 • USING YOUR BOAT 9
- ECTION 5 • FUEL SYSTEM 10
- ECTION 6 • ELECTRICAL SYSTEM 10
- AINTENANCE 11
- SECTION 1 • SAFETY 13
- ECTION 1 • SAFETY 22
- E. COLLISIONS AND LEAKING 24
- F. GROUNDING 24
- 22. WARNING LABEL LOCATIONS 29
- WARNING LABEL LOCATIONS 30
- (FIG. 1.18.1) 30
- ARNING LABEL LOCATIONS 31
- IG. 1.19.1) 31
- DO NOT CLIMB UPON OR STORE 31
- EQUIPMENT ON HARDTOP 31
- 1. DOCKING/ LIFTING/ STORAGE 33
- 2. PASSENGER LOCATIONS 34
- ! DANGER 35
- 3. PROPULSION SYSTEM 36
- (FIG. 2.5.1) 37
- 290 SUNDANCER 37
- 5. DECK LAYOUT 38
- 6. CABIN LAYOUT 39
- (FIG. 2.8.1) 40
- (FIG. 2.8.2) 40
- WITCH PAD 41
- IG. 2.9.1) 41
- IG. 2.9.2) 41
- HELM LAYOUT (FIG. 2.10.1) 42
- ! CAUTION 44
- B. POWER TRIM UNIT AND GAUGE 44
- TTITUDE LIST PUSH 45
- 10. IMPORTANT GAUGES 46
- (FIG. 2.15.1) 47
- SECTION 3 • USING YOUR BOAT 49
- 1. BILGE 59
- D. BILGE BLOWER 60
- 2. ENGINE AND STERN DRIVE 61
- SELECTION 62
- 3. UNDERWATER GEAR 63
- 4. SEACOCKS & STRAIN ERS 64
- 5. BILGE LAYOUT 66
- B ILGE LAYOUT (CONT.) 67
- SECTION 5 • FUEL SYSTEM 69
- O REPLACE THE FILTER: 72
- B. GENERAL: 72
- UELING PRECAUTIONS 72
- SECTION 6 • ELECTRICAL SYSTEM 75
- LECTRONIC INTERFACE MODULE 79
- IG. 6.5.1) 79
- IG. 6.5.2) 79
- BULB#CEC1141 83
- BULB#T125 83
- A. INTERNATIONAL RECEPTACLE 88
- IG. 6.14.1) 88
- LECTROLYTIC CORROSION AND 88
- INC ANODES 88
- LECTRICAL SCHEMATICS 91
- IRING DIAGRAM (1 OF 8) 91
- IRING DIAGRAM (2 OF 8) 92
- IRING DIAGRAM (3 OF 8) 93
- IRING DIAGRAM (4 OF 8) 93
- IRING DIAGRAM (5 OF 8) 94
- IRING DIAGRAM (6 OF 8) 94
- IRING DIAGRAM (7 OF 8) 95
- IRING DIAGRAM (8 OF 8) 96
- . 6.23.1) DRAWING NO. 09-605 97
- ABIN DC WIRING DIAGRAM 98
- TEREO SYSTEM SCHEMATIC 99
- ATELLITE STEREO DIAGRAM 108
- ORTHSTAR 6000I SYSTEM DIAGRAM 108
- NTERCONNECT DIAGRAM 109
- OLVO SYSTEM DIAGRAM 110
- ILGE HARNESS 111
- ENERATOR HARNESS 113
- ABIN HARNESS 114
- REMIER STEREO HARNESS 115
- POILER HARNESS 116
- 2. CARBON MONOXIDE MONITOR 117
- (OPTIONAL) 117
- 4. WATER SYSTEM 118
- B. WATER PUMP AND FILTER 119
- D. SHOWER SYSTEM 120
- E. TRANSOM SHOWER 121
- F. DOCKSIDE WATER INLET 121
- ! WARNING 121
- 6. HEAD SYSTEM 122
- B. VACUFLUSH 123
- C. HOLDING TANK OPERATION 123
- D. VENT FILTER 123
- 7. MACERATOR DISCHARGE PUMP 124
- SEACOCK INTERLOCK SYSTEM 124
- A. GASOLINE ENGINE BOATS 125
- B. DIESEL ENGINE BOATS 125
- 9. EN TER TAIN MENT SYSTEM 126
- 10. REFRIGERATOR 127
- 11. CANVAS 127
- 12. HORN 128
- 13. SPOT LIGHT (OPTIONAL) 128
- 14. UNDERWATER LIGHTING 128
- INTERVAL 130
- SEFUL SERVICE INFORMATION 131
- 3. INSPECTION, SERVICE AND 132
- PROTOCOL 132
- BOATS STORED ON LAND 133
- D. HEAD SYSTEM 134
- E. WATER SYSTEM 134
- F. FUEL SYSTEMS 134
- 6. SECURITY CONSIDERATIONS 135
- 5. FITTING OUT AFTER STORAGE 135
- 7. SEACOCK LUBRICATION 136
- UICK REFERENCE CHECKLIST 137
- A. BOARDING THE BOAT* 137
- OAT SYSTEMS 137
- C. WHILE UNDERWAY 139
- D. RETURNING TO PORT 139
- E. SECURING THE BOAT 140
- AINTENANCE LOG 142
- 2. FIBERGLASS AND GELCOAT 143
- 1. PAINT CLEANING AGENTS AND 143
- OTHER SUBSTANCES 143
- B. SALT CRYSTALS 144
- ANVAS AND CLEAR VINYL 145
- CRYLIC PLASTIC SHEETING 145
- LASTIC GLASS) 145
- AUGE AND SWITCH PANELS 145
- XTERIOR UPHOLSTERY FABRIC 146
- NTERIOR UPHOLSTERY FABRIC 146
- Index iv 150
Prodotti e manuali riguardandi Generatori elettrici Sea Ray 290 Sundancer
(67 pagine)© 2020, manymanuals.it. Tutti i diritti riservati | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale